So... we see you haven't signed up here on our website.  

Do you really want to sit here and be "Unregistered" all your life?  No, of course you don't!  So, click this here link and you'll take that all important first step into enlightenment! (or something, whatever...)

dreaded allocs and bcm not going green

Discussion in 'General' started by Ender, Jun 29, 2018.

  1. Ender

    Ender New Member

    Points:
    17
    I installed everything as its supposed to looking through other threads the files are exactly where they need to be i can telent through windows command prompt but when i start the server the server light goes green then the telnet turns yellow for a few seconds and goes to red and allocs and bcm show read also... when i telneted into the server and ran version it showed allocs and bcm in there... kinda tired and headed to bed but will pick up tomorrow anyone have any ideas..?
     
  2. Trekkan

    Trekkan JFF Administrator Staff Member

    Points:
    1,235
    The telnet going yellow is the issue here. The order things have to happen when running a local server are:

    Local Server
    Telnet
    BCM
    Allocs

    So the problem is telnet, it is failing to connect as you mentioned. Make sure that on the remote tab, you have the host set to "localhost", and the telnet password and port are the same values that you have set in your local settings tab, for those same values.

    Short version is that BCM and Allocs will ONLY turn green once the telnet connection is good.
     
  3. Ender

    Ender New Member

    Points:
    17
    Got it working totallly my fault somehow i downloaded the very first vesion of rat lol...
     
  4. Trekkan

    Trekkan JFF Administrator Staff Member

    Points:
    1,235
    Wow, that's impressive, I'd have to go looking for that myself! =)
     

Share This Page